Kitchenaid-refrigerator-leaking-water-from-ice-maker, was the water system flushed after filter installation or replacement? flushing the system is needed every time the filter is changed or once the refrigerator is installed to the water supply line for the first time.. The water inlet valve supplies water to the refrigerator ice and water dispenser. the valve requires a minimum of 20psi to work properly. if the water pressure is too low, the valve may not close fully when the power is shut off. as a result, the valve leaks water into the ice maker, causing it to overflow., if the defrost drain is frozen, the water will overflow the drain trough and drip down to the bottom of the compartment. this water can eventually leak onto the floor. check the defrost drain to determine if it is clogged or frozen. if the defrost drain is frozen, thaw the ice..
I understand that your kitchenaid refrigerator is leaking water at the ice dispenser flap. while you are waiting for an expert to respond, i have attached some helpful links below that may provide information to assist you with your question. have a great day! by afritz afritz earned 33,744 community points in appliances, a new icemaker is about $75. if you call someone out, the service call will be about $80. then your parts will be an additional $75.. do it your self on your schedule. only buy oem original ....
View this repair: http://www.appliancevideo.com/kitchenaid-ksrs251lss02-refrigerator-repair-frosting-up-and-leaking-water-drain-tube/ fix your trusty kitchen..., ice maker leaking from tubing frigidaire refrigerators with ice makers are connected to the main water line via a water supply line that has a shut-off valve. when your frigidaire is first installed, a company representative connects the ice maker to the supply line by a copper tubing, which is recommended..
My kitchenaid refrigerator model fkcs22evmso purchased 11/15/2009 has an ice maker that leaks water from the back of the refrigerator. when the ice maker is turned off, no leaking. when bar is returne…, when the ice maker cycles and the ice maker is ready for water, during the rotation there is a switch inside that will send power down to that valve for a few seconds. that is what opens the water valve. then the power is cut off by the ice maker and water pressure shuts it.